Connecting mobile to bluetooth and sending AT commands

vvvv beta general
5

yeah i think there is. Because it isn’t a real serial port, but a virtual one. (I think)

for hyperterminal i use COM31,
baud rate: 115200,
data bits: 8,
parity: none,
stop bits: 1,
and flow control: hardware.
The phone responds to commands sent by this.

for vvvv ive just started using 40beta17 (i hadnt updated in a while) and on the rs232 node im using
baud rate: 115200,
data bits: 8bits,
stop bits: 1bits,
parity: none,
software handshaking: none,
hardware handshaking: none,
enabled: 1 (yeah i think this ones set right :P)
and comport: COM31

after setting the setting pins i toggle the enabled node, it connects to the phone, and i bang the “do send” pin, with IObox(string)s (the former with an AT command in) attached to the input pin and output pin.

i never get confirmation from the output pin (like in hyperterminal), nor does the phone respond, despite it being connected.

i use a sony ericsson k850i

thanks for your interest and help

Rob