Spread-count-output

vvvv beta general
1

Hello people,

I’m looking for a kind of spread-count, however as a output and not as a input? I’m sure something like this exists, but I couldn’t find it…

I’m doing also some tracking with the contour node and I was looking for a way to let the contour node ignore a position if its distance from another object falls under a specific value. I tried the hysteresis-node wich works really good but I want the change to be permanent. Any Idea? I tried with a switch and flipflop but I couldn’t figure out how to set it up in a correct way…

Thanks for any help!

Greetings Leo

2

I’m looking for a kind of spread-count, however as a output and not as a input? I’m sure something like this exists, but I couldn’t find it…

I’m sure Count (Value) is what you are looking for.

< (Value) could operate your switch or even an S+H (Animation) .
see the helpfiles of those nodes…

3

thanks Kalle,

the count node is what I’m looking for :-)

for the other purpose I have to trie. I already used a mix off < > and other funktions but I was to stupid to connect them in a proper way (It was around 2 am when I tried it… :-/ I’m sure today I will do it right!

thanks again

Leo